25Service Manual – CS7010™ 03 - General Information
EcoFlex System Maintenance
You will need to purge the system of the previous detergent when switching to a different detergent.
Note: Move the machine over a oor drain before purging because a small amount of detergent will
be dispensed in the process.
To Purge When Changing Detergents (the scrub system must be off)
1. Disconnect and remove the detergent bottles.
2. Turn the key switch on and wait a few seconds for the start-up sequence to nish.
3. Press and hold the detergent switch for approximately two seconds.
4. Release the switch when the detergent purge icon appears on the display and the detergent indicator
starts ashing.
Note: Once activated, the purge process takes at least 10 seconds. Normally one purge cycle is
adequate to purge the system.
To Purge Weekly (the scrub system must be off)
1. Disconnect and remove the detergent bottles.
2. Install and connect bottles lled with clean hot water.
3. Turn the key switch on and wait a few seconds for the start-up sequence to nish.
4. Press and hold the detergent switch for approximately two seconds.
5. Release the switch when the detergent purge icon appears on the display and the detergent indicator
starts ashing.
Note: Once activated, the purge process takes at least 10 seconds. Normally one purge cycle is
adequate to purge the system.
To Next Page
Loading...
