Crescent CS7010 - To Clean the Extended Scrub System Strainer; To Clean the High Pressure Solution Filter

214Service Manual – CS7010™ 30 - Solution System
To Clean the Extended Scrub System Strainer
1. Open the recovery tank cover and
remove the debris basket.
2. Rinse any accumulated material off of the
Extended Scrub System Strainer using normal
water hose pressure.
3. Reinstall the debris basket and close the
recovery tank cover.
To Clean the High Pressure Solution Filter
1. Drain and remove the recovery tank.
Note: Place a suitable container underneath the lter to catch any solution that may leak from the
hoses.
2. Unscrew the lter cover and remove the
lter cover and screen from the lter
base.
3. Clean any accumulated dirt or debris
from the screen.
4. Reinstall the screen into the lter base.
5. Make sure the rubber washer is installed
correctly in the lter cover, then reinstall
and hand-tighten the lter cover.
Extended Scrub
System Strainer
Filter
Base
Filter
Cover