Crescent CS7010 - Maintenance and Adjustments; Changing Squeegee Blades

242Service Manual – CS7010™ 38 - Squeegee System
Maintenance and Adjustments
CAUTION: Disconnect the main battery connector before working near the drive wheel. If the
machine is unexpectedly powered on, the steering initialization routine can cause
serious injury.
Changing Squeegee Blades
1. Raise the squeegee to its retracted
position.
2. Disconnect the vacuum hose from the
rear squeegee assembly.
3. Loosen the two knobs on the squeegee
clips and pull the rear squeegee
assembly away from the squeegee
support assembly.
Note: The squeegee blades have four usable edges and can be rotated end-for-end or top-to-bottom
to position a new blade surface on the oor.
Front Squeegee Blade
1. Release the push/pull clamp and
remove the weldment strap.
2. Remove the front squeegee blade from
the squeegee weldment.
3. Rotate the existing front squeegee blade
top-to-bottom or end-for-end to position a
new blade surface on the oor, or install
a new front squeegee blade onto the
squeegee weldment pins.
4. Reinstall the weldment strap, then
secure the push/pull clamp.
Grease
Fitting
Rear
Squeegee
Assembly
Squeegee
Support
Assembly
Knob (2)
Squeegee
Clip (2)
Front
Squeegee
Blade
Squeegee
Weldment
Push/Pull
Clamp
Weldment
Strap