Crescent CS7010 - PM Checklist

26Service Manual – CS7010™ 03 - General Information
PM Checklist
Nilsk-Advance CS7010
Ref Operational Inspection Items OK
Not
OK
Defect Codes
(circle)
1
Engine idle speed. LP - 1700 RPM; diesel - 1700 RPM
AInconsistent
2
Engine run speed. LP - 2500 RPM; diesel - 2200 RPM
ALowpower
3
Engine maximum power at run speed.
ALowpower
4
Drive pedal operation (forward/reverse and any neutral creep) A B
5
Drive system performance (max forward transport speed) noisy slow
6
Brakes (check both service and parking) A B W
7
Steering not functioning
8
Main broom raise/lower B D
9
Main broom on/off B D
10
Side sweep brooms raise/lower A B
11
Side sweep brooms on/off B L
12
DustGuard™ (water nozzles) on/off A C L
13
Dust control lter C D
14
Scrub system (raise/lower and auto scrubbing functions)
15
Scrub brushes on/off (will drift)
16
Scrub brush (pressure settings 1, 2 and3) A B
17
Solution control (on/off and ve ow settings) C D
18
Test and purge the EcoFlex™ detergent system (if so equipped) C L W
19
Squeegee system (raise/lower and auto lift in reverse)
20
Vacuum - 48” of H2O sealed; 25” to 30” of H2O with 1” orice C L
21
Headlights, gauges, optional beacon, backup alarm
22
Tilt steering mechanism and seat adjustment lever
Ref Visual Inspection Items OK
Not
OK
Defect Codes
(circle)
23 Main broom bristles min. bristle length 2” [5 cm] A B D W
24 Main broom motor B D
25 Side sweep broom bristles min. bristle length 3” [7,63 cm] A B D W
26 Side broom motors B D
27 Scrub brush motors B D
28 Main scrub brushes, check for wear and rotate D W
Customer
Address
City St Zip
Model # Serial # Hours
Defect Codes
A → Needs adjustment
B → Binding
C → Contaminated, dirty
D → Damaged, bent, or torn
L → Leaks
M → Missing
W → Worn out