Crescent CS7010 - Configuration Menu; System Menu

44Service Manual – CS7010™ 04 - Control System
Conguration Menu
The conguration menu provides access to congure the machine based on which options are installed. If you
install an option to a customer’s machine, you will need to congure the controller to specify that the option
is installed, or the option may not function. Additional information is contained in the instruction sheets
that accompany the option kits.
Machine Type: This sets the type of power plant the machine uses. The choices are: Propane, Battery,
Diesel, and Gas.
Battery: This sets the battery type for the purpose of battery voltage monitoring. The choices are Wet,
Bench, and Sealed. The battery types will have slightly different voltage levels during their discharge cycles.
Brand: This sets the branding of the machine (Nilsk or Advance). This should never be changed unless you
are replacing the main controller.
Detergent: This sets whether the detergent system is installed.
Ecoex: This sets whether the EcoFlex detergent pump system is installed.
Dust Guard: This sets whether the dust guard water spray is installed.
Extended Scrub: This sets whether the extended scrub option is installed.
Backup Alarm: This sets whether the backup alarm is installed.
Signal Lights: This sets whether the optional signal lights are installed.
Plugged Filter: This sets whether the plugged lter sensor is installed.
Hopper Temp: This sets whether the hopper temperature sensor is installed.
Pressure Wash: This sets whether the optional pressure wash pump and wand are installed.
Display: This sets the units of the display between US imperial and Metric.
TrackClean: This sets whether the TrackClean module is installed.
System Menu
The system menu displays the rmware revision number and
the serial number of the control board. It also provides access for
updating the rmware.
System
Firmware
Back
Select
Serial Number
Install Firmware
99.99.99.9
15.14.0009