13Service Manual – CS7010™ 03 - General Information
Safety
Symbols
It is important for you to read and understand this manual. The information it contains relates to protecting
your safety and preventing problems. The symbols below are used to help you recognize this information.
DANGER: Indicates a potentially hazardous situation which, if not avoided, will result in death or
serious injury.
WARNING: Indicates a potentially hazardous situation which, if not avoided, could result in death
or serious injury.
CAUTION: Indicates a potentially hazardous situation which, if not avoided, could result in minor
or moderate injury.
Note: Indicates an important informational message.
General Safety Instructions
These safety instructions are included to warn you of potential bodily injury or property damage.
DANGER: Engine-powered machines emit exhaust gasses, including carbon monoxide, which
can cause serious injury or death. Always provide adequate ventilation when using
the machine.
CAUTION: Read and understand all safety warnings and instructions. Failure to follow the
warnings and instructions may result in electric shock, re, and/or serious injury.
− To avoid personal injury, this machine should be used only by properly trained and
authorized persons. This machine is not intended for use by persons with reduced
physical, sensory, or mental capabilities.
− To avoid pinching or crushing hazard, stay clear of the rear drive wheel when the
machine is initializing or running. When the machine is initialized, the steering system
will turn the wheel to the side to identify home and limit positions of the wheel steering.
− Do not operate the machine near toxic, dangerous, ammable and/or explosive
materials. This machine is not suitable for collecting dangerous or hazardous materials.
− In case of re, use a powder re extinguisher, not a water-based extinguisher.
− Do not use on surfaces having a gradient exceeding that marked on the machine. While
on ramps or inclines, avoid sudden stops when loaded. Avoid abrupt sharp turns.
− Do not use the machine without a falling object protective structure in areas where it is
likely that the operator may be struck by falling objects.
− Disconnect the power source and/or batteries before servicing electrical components.
Turn the key switch off before changing brushes or opening access panels.
− Never work under a machine without safety blocks or stands to support the machine.
− Do not dispense ammable cleaning agents, operate the machine on or near these
agents, or operate in areas where ammable liquids exist.
− When using oor cleaning detergents, follow all safety and handling instructions of the
To Next Page
Loading...
