Configuring Device Information 233
Configuring Static Address Parameters Using CLI Commands
The following table summarizes the equivalent CLI commands for configuring static address
parameters as displayed in the
Static MAC Address
page.
The following is an example of the CLI commands:.
Table 7-57. Static Address CLI Commands
CLI Command Description
bridge address
mac-address
{
ethernet
interface | port-channel port-channel-
number
} [
permanent
|
delete-on-reset
|
delete-on-timeout
|
secure
]
]
Adds a static MAC-layer station source
address to the bridge table.
show bridge address-table [vlan vlan]
[ethernet interface | port-channel port-
channel-number]
Displays entries in the bridge-forwarding
database.
Console# show bridge address-table
Aging time is 300 sec
vlan mac address port type
---- ------------ ---- --------
1
00:60:70:4C:73:FF
g8
dynamic
1
00:60:70:8C:73:FF
g8
dynamic
200
00:10:0D:48:37:FF
g9
static
g8 00:10:0D:98:37:88
g8
dynamic
To Next Page
Loading...
