Dell PowerConnect 5324 User Manual

Viewing Statistics 303
Interface — Specifies whether statistics are displayed for a port or LAG.
Refresh Rate — Amount of time that passes before the interface statistics are refreshed.
Frame Check Sequence (FCS) Errors — Number of FCS errors received on the selected interface.
Single Collision Frames — Number of single collision frames received on the selected interface.
Multiple Collision Frames — Number of multiple collisions frames received on the selected
interface.
Single Quality Error (SQE) Test Errors — Number of SQE test errors received on the selected
interface.
Deferred Transmissions — Number of deferred transmissions on the selected interface.
Late Collisions — Excessive
Collisions
— Number of excessive collisions received on the selected interface.
Internal MAC Transmit Errors — Number of internal MAC transmit errors on the selected
interface.
Carrier Sense Errors — Number of carrier sense errors on the selected interface.
Oversize Packets — Number of oversized packet errors on the selected interface.
Internal MAC Receive Errors — Number of internal MAC received errors on the selected
interface.
Single Quality Errors (SQE) Test Errors — The amount of SQE test errors received on the
selected interface.
Receive Pause Frames — Number of received paused frames on the selected interface.
Transmitted Paused Frames —
Displaying Etherlike Statistics for an Interface
1 Open the Etherlike Statistics page.
2 Select an interface in the Interface field.
The interface’s Etherlike statistics are displayed.
Resetting Etherlike Statistics
1 Open the Etherlike Statistics page.
2 Click Reset All Counters .
The Ethernetlike statistics are reset.

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2