Electrical system
Fiat CODE
Bravo-Brava
When the CODE warning light goes out, turn
the key (2) to the ignition off (STOP)
posi-
tion.
Within 10 seconds:
- withdraw the keky (2) from the ignition
switch block;
- insert the MASTER key in the ignition
switch block again and turn it to the ON
position
( +
15);
the CODE warning light
comes on for 0.7 s.
When the CODE warning light goes out, turn the
MASTER key to the off (STOP) position.
The memorization procedure is completed (me-
morization of the Master Code in the engine
con-
trol unit) as follows:
- turn the MASTER key to the ignition on
(
+ 15)
position;
- keep the MASTER key at the ON position for
about 3 seconds;
- the CODE warning light comes on for 0.7 s and
goes out definitively if the procedure has been
successful (positive result);
- the CODE warning light comes on for 0.7 s and
starts flashing again after about 2 seconds if
the memorization has NOT been successful
(negative result). In this case, withdraw the
MASTER key and repeat the key memorization
procedure from the beginning.
Also refer to the diagram on the next page.
66
Publication no. 506.670/01
To Next Page
