Bravo-Brava
P4A19AL07
Electrical equipment
Alarm
55.
8. After about 2 seconds the LED will emit
another flash to request the input of the
last figure (the 3).
pulses
9. Immediately press the button for the re-
ceiver as many times as indicated by the
last digit of the password (for example: 3
times);
it should be noted that for each impulse
the LED will come on briefly to give a vi-
sual confirmation.
After having entered the four figures of the
password,
the LED in the receiver should be-
have in the following way:
a) it should start to flash for 10 sees if the
password has been correctly entered
(opening of the memory);
b) it should come on constantly for 10 sec-
onds to indicate that the password has
not been correctly entered or that it does
not correspond to any of the codes for the
remote controls programmed. If this is the
case,
after the LED goes out, the correct
password should be reintroduced starting
from point 1.
10.
Whilst the LED is flashing, press the but-
ton in the courtesy light and keep it
pressed;
the LED should continue to
flash.
Copyright by Fiat Auto
111
-96 - Cancels and replaces
147
To Next Page
Loading...
