Bravo-Brava
Bodywork
Window glasses
70.
Refitting
- Fit the trim on the windscreen avoiding
touching the area where the adhesion pro-
moter (primer) has been applied with your
fingers.
- Carry out a test fitting to centre the
wind-
screen perfectly and make reference marks.
The sliding retaining mountings lo-
cated In the lower part should sup-
port the windscreen towards the top
and keep It aligned with the
roof.
Using a pneumatic gun, extrude a bead of
sealant along the perimeter of the
wind-
screen as evenly as possible (if there is ex-
cess,
level the bead using a slice of potato).
In the lower part of the windscreen
apply the sea/ant scrupulously
fol-
lowing the figures given In the dia-
gram to prevent ft ending up on the
retaining mountings.
P4A051M03
Copyright by Fiat Auto
51
To Next Page
Loading...
