Bodywork
Window glasses
70.
- Using the special suction pads, place the windscreen in position immediately after applying the
sealant.
- Using suitable belts and shims, exert slight pressure on the windscreen so that the trim is correctly
aligned with the pillars.
Keep the glass under pressure for at least
1
hour. During this period it is possible to let water run over the
window to locate any possible penetration points and accelerate the polymerization of the sealant.
- Any excess sealant inside the pillars can be removed when the sealant has hardened, cutting it with a
blade and removing it with pliers.
Take care not to damage the serigtaphed area of the windscreen with the blade.
- Refit the elements removed previously and clean the window.
The vehicle should not be handed back for at least 15 hours after the windscreen has been stuck.
Bravo-Brava
52
Print no. 506.670
To Next Page
Loading...
