Bodywork Bravo-Brava
Replacing structural body panels
70.
Removing off cuts and preparing edges of bodyshell
1.
Remove the spot welds along the entire perimeter of the edge of the bodyshell, using
a
special cutter.
2.
Remove the metal off cuts using pliers.
3. Straighten the edges with a hammer and dolly block.
4.
Remove the weld residues using a disc grinder.
5. Apply the IVI Epox epoxide type primer or an electro-weldable galvanized paint or an equivalent pro-
duct, to the areas previously ground.
j
Preparing the replacement parts
1.
Remove the anti-corrosion treatment from the entire perimeter of the inside and the outside of the re-
placement part using a disc grinder.
2.
Use electro-galvanizing paint on the edges previously treated.
108
Print
no.
506.668/01
To Next Page
Loading...
