Bravo Bodywork
Replacing structural body panels
70.
Positioning the replacement part
1.
Carefully place the replacement part in position, from the inside of the underdoor side member rear
reinforcement.
2.
Fix the replacement part to the bodyshell using the special self-locking clamps.
Welding the spare part
1.
Carry out spot welding by the front pillar frame and the upper edges.
2.
Using the MIG welder fill the holes made previously in the bodyshell.
Proceed with fitting the front pillar and the underdoor side member (see: "Replacing structural body
panels - Replacing Front pillar" and "Replacing body panels - Replacing underdoor side member").
Copyright by
Fiat
Auto
127
To Next Page
Loading...
