113
10. Processor Control GUI Launcher
Processor Control GUI Launcher allows you to connect multiple FA-9600 units and switch the Windows
GUI control unit within them. Install the Processor Control GUI Launcher into your computer and register
FA-9600 units.
The GUI Launcher can run in the same system as FA-9600 Windows GUI. (See Sec. 9-1. “System
Requirements.”)
10-1. Installing the GUI Launcher
(1) Open the Processor Control GUI Launcher folder in the supplied CD-ROM and double-click
the Setup file to start the setup wizard.
(2) When the following window appears, click Next.
(3) Click Next again.
(4) After the installation is completed, click Close to quit the setup wizard.
10-2. Starting Processor Control GUI Launcher
Once the GUI Launcher is installed, its icon is created on the desktop.
Double-click the icon to start the GUI Launcher.
When the GUI Launcher starts, the following Launcher screen appears.
To Next Page
Loading...
Need help?
General