49
5-17. INPUT LINKAGE PROCESS (AUDIO)
An event (menu settings) can be automatically loaded by linking to ARIB Audio mode (data in the
control signal defined by ARIB STD-B39). input signal format. To check the input Audio Mode
information, see Sec. 7-13. “INPUT ARIB B39 AUDIO MODE.”
Note that signal processing from data analysis to even loading may take a certain time, more than
a frame in some cases.
To use auto (linkage) event load, a corresponding event should be created and uploaded in
advance. (See Sec. 13-3-2-2. "Auto Loaded Events (Event 101 and higher)” in Sec. 13-3-2 “Event
Data”.)
Simultaneous 4K/HD
Dual HD
3D-LUT (FS1)
Enables/disables auto event load linked to ARIB
Audio Mode.
5-18. DYNAMIC RANGE GAIN CONTROL
Simultaneous 4K/HD
Dual HD
3D-LUT (FS1)
Sets whether to keep the gain difference between
FS 1 and 2. Setting to Enable allows you to set
Gain, Color Correction (Differential, Balance)
and Clip (RGB Clip, YCbCr Clip) by preserving
the difference set under Dynamic Range Gain.
Sets the RGB dynamic range gain in the linear
scale space.
Sets the gain difference between SDR and HDR.
The total gain is equal to addition of SDR Gain
and Dynamic Range Gain values. This setting is
ignored for conversions between SDR signals or
between HDR signals, .
Displays the gain difference between before and
after conversion.
Displays the conversion method being processed
between SDR and HDR.
To Next Page
Loading...
Need help?
General