SECTION 5 - REMOVAL - REFITTING OF THE MAIN ENGINE COMPONENTS
17
CURSOR SERIES
Print P4D32C006 E Base - 03/2015
Figure 43
225062
Tighten the screws securing the turbocharger following the
sequence indicated in the figure.
Figure 44
227761
Mount the oil delivery pipe to turbocharger (3) and tighten
screws of the bracket (1) and the fitting (2) to the torque
showninthetable.
Fit the engine oil return pipe from the turbocharger (5) with
the new gaskets and tighten the screws (4, 6) to the torque
indicated in the table.
Ref.
No. Description
Tightening
torques
(1) 1 M10 screw 10 ± 1 Nm
(2) 1 Fitting M16X1.5X12 42.5 ± 2.5Nm
(4, 6) 4 M8 x 1.25 screws 24.5 ± 2.5 Nm
Figure 45
227760
Connect the sleeve (3) of the combustion air intake pipe to
the turbocharger and tighten the clamps.
Tighten the screws (2) of the oil delivery pipe to the
turbocharger to the torque indicated in the table.
Ref.
No. Description
Tightening
torques
(2) 2 M8 x 1.25 screws 24.5 ± 2.5 Nm
Connect the air intake pipe (1) to the aftercooler and tighten
clamp and collar.
To Next Page
Loading...
Need help?
General
