SECTION 6 - GENERAL MECHANICAL OVERHAUL
71
CURSOR SERIES
Print P4D32C006 E Base - 03/2015
Figure 167
α
221111
Fit the double gear (1) and tighten the screws (2) to the torque
indicated in the table.
NOTE Lubricate the screws ( 2) with engine oil before
assembly.
Ref. No. Description
Tightening
torques
(2) 3
Screws M12 X 1.75 X 90
Step 1 30 ± 1.5 Nm
Step 2 90˚
Fitting flywheel case
Figure 168
47592
Apply LOCTITE 5970 onto the housing using the designated
tool (1) as indicated in the figure.
NOTE Fit the flywheel housing within 10 minutes of
applying the sealant .
Figure 169
225008
Use a torque wrench to tighten the screws to the specific
tightening torque in the sequence shown in the figure.
Ref.
No. Description
Tightening
torques
(A) 4 Screws M12 X 1.75 X 40 63 ± 7Nm
(B) 2 Screws M12 X 1.75 X 70 63 ± 7Nm
(C) 10 Screws M12 X 1.75 X 100 63 ± 7Nm
(D) 2 Screws M12 X 1.75 X 193 63 ± 7Nm
(E) 1 Screws M12 X 1.75 X 120 63 ± 7Nm
(F) 1 Screws M10 X 1.5 X 30 45.5 ± 4.5 Nm
Figure 170
225007
Tighten the screws securing the flywheel housing to the
crankcase following the sequence indicated in the figure.
To Next Page
Loading...
