FPT CURSOR Series - Section 6: General Mechanical Overhaul Procedures

SECTION 6 - GENERAL MECHANICAL OVERHAUL
1
CURSOR SERIES
Print P4D32C006 E Base - 03/2015
SECTION 6
General mechanical overhaul
Page
ENGINE DISASSEMBLING 5.................
- Disassembly of G-Drive components 5........
- Removal of components hindering
bracket assembly 6.......................
- Fitting the engine on the rotating stand 8......
DISASSEMBLY OF ENGINE AT BENCH
(COMPONENTS AT THE FRONT) 9........
- Damper flywheel removal 9................
- Coolant pump alternator drive belt disassembly 9
- Alternator removal 9......................
- Alternator support removal 10...............
- Electromagnetic coupling pulley removal 10.....
- Assembly of auxiliary parts 10................
- Thermostat case removal 10.................
- Crankshaft front gasket removal 11............
DISASSEMBLY OF ENGINE AT BENCH
(COMPONENTS AT EXHAUST SIDE) 11.....
- Turbocharger and exhaust manifold removal 11..
- Heat exchanger removal 12.................
DISASSEMBLY OF ENGINE AT BENCH
(COMPONENTS AT THE INTAKE SIDE PART 1) 12
- Disassembly of the starter motor 12...........
- Inlet manifold removal 12...................
- Engine control unit removal 13...............
DISASSEMBLY OF ENGINE AT BENCH
(COMPONENTS AT THE REAR SIDE PART 1) 13
- Blow-by case removal 13...................
- Blow-by filter removal 13...................
- Timing gear cover removal 14................