8
SECTION 4 - SCHEDULED MAINTENANCE
CURSOR SERIES
Base - 03/2015 Print P4D32C006 E
Change engine lubricant oil
Figure 5
227779
Only proceed when the engine is not turning and is at low
temperature so as not to run the risk of burns.
- Place a suitable container for collecting the spent oil un-
der the oil sump next to the lubricant oil drain plug (3).
- Unscrew the lubricant oil drain plug (3).
Figure 6
227776
- afterwards extract the oil level dipstick (1) and remove
the lubricant oil cap (2) to assist the flow of the engine
lubricant oil.
- Wait until the oil sump has completely emptied, then
retighten the lubricant oil drain plug (3, Figure 5) to the
torque indicated in the table
Ref.
No. Description Torque
3 1 Oil drain plug 95 ± 10 Nm
Proceed with the refilling operation through the hole (2) si-
tuated on the tappet cover, using lubricant oil that complies
with the international standards as indicated in Section 1 -
General table ”General Characteristics”.
- Use the oil dipstick (1) to check that the lubricant oil level
does not exceed the ”Max” limit.
- Retighten the lubricant oil cap (2).
When changing the replacement of the engine lubricant oil
it is necessary to replace the oil filter (see paragraph ENGINE
OIL FILTER REPLACEMENT).
Clean the plugs before performing the operations
so as to minimize the risk of contaminating the sy-
stem.
After changing the engine lubricant oil make sure
that the level does not exceed the ”Max” limit on
the oil level dipstick.
Make sure that the dipstick is fully inserted and
that the filler plug is tightened fully in the clockwise
direction.
!
Dispose of consumable materials and the parts in
contact with them (for example filters) in accor-
dance with the law.
To Next Page
Loading...
