18
SECTION 5 - REMOVAL - REFITTING OF THE MAIN ENGINE COMPONENTS
CURSOR SERIES
Base - 03/2015 Print P4D32C006 E
EXHAUST MANIFOLD
REMOVAL-REFITTING
Removal
Figure 46
227760
Slacken the clamp and collar and remove the combustion air
intake pipe (1) to the aftercooler.
Undo the screws (2) of the oil deliver pipe to turbocharger
Ref.
No. Description
(2) 2 M8 x 1.25 screws
Slacken the clamps and remove the sleeve (3) of the
combustion air intake pipe to the turbocharger.
Figure 47
227761
Loosen the screw of the bracket (1) and fitting (2) and
remove the oil supply pipe to the turbocharger (3).
Undo the screws (4, 6) and remove the oil return pipe from
the turbocharger (5) with its gasket s .
Ref.
No. Description
(1) 1 M10 screw
(2) 1 Fitting M16X1.5X12
(4, 6) 4 M8 x 1.25 screws
Figure 48
227762
Unscrew the fastening screws (1) and remove the exhaust
manifold (2) together with the turbocharger (3) and the
gaskets.
Ref.
No. Description
(1) 24 ScrewsM10X1.5X70
Refitting
Figure 49
227762
Fit the exhaust manifold (3) wit h new gaskets together with
the turbocharger (2). Fit the fastening screws (1) to the
exhaust manifold and tighten them to the torque indicated
in th e table.
Ref.
No. Description
Tightening
torques
(1) 24
ScrewsM10X1.5X70
Step1 30±5Nm
Step 2 60 ± 5 Nm
To Next Page
Loading...
