68
SECTION 6 - GENERAL MECHANICAL OVERHAUL
CURSOR SERIES
Base - 03/2015 Print P4D32C006 E
Checking crankshaft shoulder clearance
Figure 157
47588
The thrust clearance is checked by placing a specific dial gauge
(0 ÷ 5mm) 99395603 (1) on the crankshaft (2) as shown in
the figure.
If the value obtained is higher than specified, replace the rear
thrust half-bearings and repeat the clearance check.
ASSEMBLY OF ENGINE AT BENCH
(COMPONENTS AT THE BOTTOM)
Suction strainer installation
Figure 158
221114
Turn the engine and position the oil suction strainer (1).
Tighten the screws (3) and secure the flange.
Tighten the screws (2) and secure the supports.
Ref.
No. Description
Tightening
torques
(2,3) 6 M8 X 1.25 24.5 ± 2.5 Nm
Oil sump assembly
Figure 159
60665
Arrange the gasket (4) on the oil sump (1), position the spacer
(3) and fit the sump onto the engine crankcase screwing in the
screws (2) to the torque in the table.
Ref.
No. Description
Tightening
torques
(2) 16 M10X1.5 screws
(2) 12
Step1 45±4.5Nm
Step 2 45 ± 4.5 Nm
To Next Page
Loading...
Need help?
General
