FPT CURSOR Series - Section 4: Scheduled Maintenance Procedures

SECTION 4 - SCHEDULED MAINTENANCE
1
CURSOR SERIES
Print P4D32C006 E Base - 03/2015
SECTION 4
Scheduled maintenance
Page
SCHEDULED MAINTENANCE 3.............
- Introduction 3...........................
CHECKS TO BE MADE DURING PERIODS OF USE -
HOW TO PROCEED 5...................
- Check the engine lubricant oil level 5.........
- Engine coolant level check (example) 5........
- Engine visual inspection 6..................
- Inspection cleaning of the air filter and relative seat 6
- Check tension and condition of ancillary belt 7..
- Exhaust gas pipes(s) condition check 7........
PERIODIC MAINTENANCE - HOW TO PROCEED 7
- Draining the water from the fuel prefilter
(if any) 7...............................
- Condensed water drainage from fuel tank 7....
- Change engine lubricant oil 8...............
- Change lubricant oil filter 9.................
- Replace fuel prefilter (if fitted) (example) 10.....
- Replacing fuel filter 11......................
- Change air filter 12........................
- Replace auxiliary member drive belt 12........
- Replacing blow-by filter element 12...........
UNSCHEDULED MAINTENANCE -
HOW TO PROCEED 13...................
- Visual turbocharger inspection 13.............
- Clean the heat exchanger (radiator) 13........
- Check the tappet clearances and adjusting
if necessary 13............................
- Replace engine coolant 14..................