FPT CURSOR Series - Oil Pressure and Temperature Sensor

NOTE
190518
190517
190519
Figure 18
Figure 19
Figure 20
Oil pressure and temperature sensor
It is mounted on the crankcase.
The signals measured are transmitted to the EDC17 control
unit which in turns sends the information to the instrument
panel (indicator / pressure warning light).
Turbocharging air pressure and temperature
sensor
This is fitted on the intake manifold; the sensor described ser-
ves to measure the absolute pressure on the intake manifold
and the supply air flow temperature
The engine oil temperature is only used by the
EDC 17 control unit and is not sent to the instru-
ment panel.
1
2
3
4
225063
Figure 21
14
SECTION 3 - ELECTRIC EQUIPMENT
CURSOR SERIES
Base - 03/2015 Print P4D32C006 E
Pin Description ECU pin
1 Ground (-) EDC17, pin A/6
2 Temperature signal EDC17, pin A/13
3 Power supply (5V) EDC17, pin A/31
4 Pressure signal EDC17, pin A/35
Pin Description ECU pin
1 Ground (-) EDC17, pin A/90
2 Temperature signal EDC17, pin A/37
3 Power supply (5V) EDC17, pin A/07
4 Pressure signal EDC17, pin A/86