190510
190511
210300
Figure 11
Figure 12
Figure 13
Camshaft sensor
This inductive sensor is located on the camshaft.
The signal generated by this sensor is used by the EDC17
control unit as the injection timing signal.
The sensor generates signals obtained from the magnetic
flow lines which come towards the teeth of the phonic wheel
fitted on the shaft (number of teeth: 7).
WARNING
The sensor gap is not adjustable.
S
12
SECTION 3 - ELECTRIC EQUIPMENT
CURSOR SERIES
Base - 03/2015 Print P4D32C006 E
Pin Description ECU pin
1 Signal (+) EDC17, pin A/67
2 Signal (-) EDC17, pin A/68
Specifications Measurement Conditions
Resistance 850 - 870
tightening torque 6-10Nm
To Next Page
Loading...
Need help?
General
