28
SECTION 5 - REMOVAL - REFITTING OF THE MAIN ENGINE COMPONENTS
CURSOR SERIES
Base - 03/2015 Print P4D32C006 E
INTAKE MANIFOLD REMOVAL-REFITTING
Removal
Figure 76
227769
Disconnect the combustion air intake pipe to the engine (4)
acting on the clamp.
Disconnect the electrical connection of the air temperature
and pressure sensor.
Unscrew the screws (1) and remove the intake manifold (2)
together with the engine preheating resistor (3) and its gasket.
Ref.
No. Description
(1) 3 Screws M10 X 1.5 X 100
(1) 2 Screws M10 X 1.5 X 130
(1) 1 Screws M10 X 1.5 X 150
Refitting
Figure 77
227769
Fit the intake manifold (2) together with the engine preheating
resistor (3) and its gasket and tighten screws (1) to the torque
showninthetable.
Connect the combustion air intake pipe to the engine (4) and
tighten the clamp.
Ref.
No. Description
Tightening
torques
(1) 3 Screws M10 X 1.5 X 100 50± 5 Nm
(1) 2 Screws M10 X 1.5 X 130 50 ± 5 Nm
(1) 1 Screws M10 X 1.5 X 150 50 ± 5 Nm
Connect the electrical connection of the air temperature and
pressure sensor.
Connect the combustion air intake pipe to the engine (4) and
tighten the clamp.
Figure 78
225039
Observe the order of tightening indicated in the diagram.
To Next Page
Loading...
