SECTION 6 - GENERAL MECHANICAL OVERHAUL
25
CURSOR SERIES
Print P4D32C006 E Base - 03/2015
Cylinder liners Removal
Figure 68
47577
Position the extraction tool 99360706 (2) and the plate
99360728 (4), as shown in the figure, making sure that the pla-
te (4) rests correctly on the cylinder liner.
Fasten the screw nut (1) and take off the cylinder liner (3) from
the crankcase.
Cylinder liner refitting and protrusion check
Figure 69
208341
Always replace the watertight rings (3, 4 and 5).
Install the adjustment ring (1) on the cylinder liner (2); lubricate
the lower part of the liner and install it in the cylinder assembly
using the proper tool.
NOTE The adjustment ring (1) is supplied as spare
parts in the following thicknesses: 0.08 mm -
0.10 mm - 0.12 mm - 0.14 mm.
Figure 70
60520A
Check the protrusion of the cylinder liners using the tool
99360334 (2) together with spacers 99360336 and tightening
the screw (1) to a torque of 225 Nm
Figure 71
60520B
Using the dial gauge (0-5mm) 99395603 supplied with a base
with dial gauge carrier 99370415 (3), check that the protrusion
of the cylinder liners in relation to the contact surface of the
cylinder heads is 0.045 - 0.075, if this is not the case, replace
the adjustment ring (1, Figure 69), supplied as a spare part in
different thicknesses.
To Next Page
Loading...
Need help?
General
