FPT CURSOR Series - Crankshaft Rear Gasket Removal; Removing Engine Mounts; Flywheel Case Removal; Double Gear Removal

SECTION 6 - GENERAL MECHANICAL OVERHAUL
17
CURSOR SERIES
Print P4D32C006 E Base - 03/2015
Crankshaft rear gasket removal
Figure 40
60500
Fit puller 99340053 (2) and take off the seal (1).
Removing engine mounts
Figure 41
221109
Unscrew the screws (4) and remove the engine suspension
(3).
Undothescrews(1)andremovecover(2)completewith
O-ring.
Ref.
No. Description
(1) 3 Screws M8 X 1.25 X 20
(4) 8 M16x2screws
Flywheel case removal
Figure 42
225018
Unscrew the screws (1) and remove the flywheel case (2).
Ref.
No. Description
(1) 10 Screws M12 X 1.75 X 100
(1) 4 Screws M12 X 1.75 X 40
(1) 1 Screws M12 X 1.75 X 120
(1) 2 Screws M12 X 1.75 X 193
(1) 2 Screws M12 X 1.75 X 70
(1) 2 Screws M10 X 1.5 X 30
Double gear removal
Figure 43
221111
Remove screws (2) and disassembly the double gear (1).
Ref.
No. Description
(2) 3 Screws M12 X 1.75 X 90