FPT CURSOR Series - Page 134

50
SECTION 5 - REMOVAL - REFITTING OF THE MAIN ENGINE COMPONENTS
CURSOR SERIES
Base - 03/2015 Print P4D32C006 E
Figure 148
α
60566
Use tool 99395216 (1) for angle tightening to the torque
shown in the table.
Ref.
No. Description
Tightening
torques
(-) 20 Screws M18 X 2 X 196
(-) 6
Screws M18 X 2 X 175
Step 1 90 ˚
Step 2 90 ˚
Figure 149
47592
Apply LOCTITE 5970 onto the housing using the designated
tool (1) as indicated in the figure.
NOTE Fit the flywheel housing within 10 minutes of
applying the sealant.
Figure 150
225008
Use a torque wrench to tighten the screws to the torque
showninthetable.
Ref.
No. Description
Tightening
torques
(A) 4 Screws M12 X 1.75 X 40 63 ± 7 Nm
(B) 2 Screws M12 X 1.75 X 70 63 ± 7 Nm
(C) 10 Screws M12 X 1.75 X 100 63 ± 7 Nm
(D) 2 Screws M12 X 1.75 X 193 63 ± 7 Nm
(E) 1 Screws M12 X 1.75 X 120 63 ± 7 Nm
(F) 2 Screws M10 X 1.5 X 30 45.5 ± 4.5 Nm
Figure 151
225007
Tighten the fastening screws following the sequence indicated
in the figure.