SECTION 5 - R EMOVAL - REFITTING OF THE MAIN ENGINE COMPONENTS
53
CURSOR SERIES
Print P4D32C006 E Base - 03/2015
Figure 159
225010
Tightening sequence
Step 1 1-2-3-4-5
Step 2 6-7-8-9-10
Figure 160
160654
Apply the gauge 99395225 (1).
Check and adjust the position of the connecting rod (3) for the
transmission gear; tighten the screw (2) to the torque specified
in the table.
Ref.
No. Description
Tightening
torques
(2) 1
Screws M8 X 1.25 X
16
24.5 ± 2.5 Nm
Figure 161
α
221107
Fit the transmission gear (1) and tighten the screws (2) to the
torque indicated in the table.
Ref.
No. Description
Tightening
torques
(2) 8
Screws M12 X 1.7 X 110
Step 1 30 ± 1.5 Nm
Step 2 90 ˚
NOTE Lubricate the screws (2) with engine oil before
assembly.
To Next Page
Loading...
