FPT CURSOR Series - Page 163

SECTION 6 - GENERAL MECHANICAL OVERHAUL
15
CURSOR SERIES
Print P4D32C006 E Base - 03/2015
Figure 33
227747
Unscrew the nutes (1), remove the plugs, undo the fittings, and
remove the HP fuel pipes (2).
Ref.
No. Description
(1) 2 Nuts M6 X 1
(2) 4 Fittings M16 X 1.5
The high pressure pipes which have been removed
cannot be used again and must be replaced.
Undo screws (5), fitting (7), disconnect the collars and
removetheLPfuelpipe(4).
Unscrew the fittings and remove the fuel return pipe (6).
Ref.
No. Description
(5) 2 Screws M8 X 1.25 X 16
(6) 2 Fittings M18 X 1.5
(7) 1 Fitting M18 X 1.5
Figure 34
221104
Unscrew the screws (1,2,4) and remove the bracket (3).
Unscrew the screws (5) and remove the high pressure pump.
Ref.
No. Description
(1) 2 Screws M10 X 1.5 X 20
(2) 2 Screws M8 X 1.25 X 20
(5) 4 Screws M12 X 1.5
Figure 35
160624
Unscrew the retaining screws (1) and remove the flange (2)
supporting the high pressure pump.
Ref.
No. Description
(1) 6 Screws M8 X 1.25 X 30