SECTION 6 - GENERAL MECHANICAL OVERHAUL
95
CURSOR SERIES
Print P4D32C006 E Base - 03/2015
Assembling the engine front suspensions.
Figure 238
α
224056
Fit the LH front engine suspension (2) and tighten the screws
(1) to the torque indicated in the table.
Proceed likewise to assemble the suspension on the right.
Ref.
No. Description
Tightening
torques
(1) 3
M16x2screws
Step 1 120 Nm
Step 2 45˚
Assembly of the turbocharger oil supply and return
pipe oil pressure and temperature sensor and oil
pressure regulator valve
Figure 239
224055
Fit the engine oil delivery pipe to the turbocharger with new
gaskets and tighten the fastening screws (1) to the
turbocharger to the torque indicated in the table.
Ref.
No. Description
Tightening
torques
(1) 2 M8 x 1.25 screws 24.5 ± 2.5 Nm
Figure 240
224054
Screw the fitting (2) of the oil intake pipe to the turbocharger
and the screw of the bracket (7) to the torque indicated in the
table.
Fit the turbocharger oil outlet pipe with the new gaskets and
tighten the screws (4) and (6) to the torque indicated in the
table.
Fit the oil pressure control valve and tighten the screws (3) to
the torque indicated in the table.
Ref.
No. Description
Tightening
torques
(2) 1
Fitting
M16 X 1.5 X 12
42.5 ± 2.5 Nm
(4) (6) 4 M8 x 1.25 screws 24.5 ± 2.5 Nm
(3) 2 Screws M8 X 1.25 X 20 25 ± 2.5 Nm
Fit the oil pressure and temperature sensor with the new
O-ring and tighten the screws (1) to the torque indicated in
the table.
Ref.
No. Description
Tightening
torques
(1) 2 Screws M6 11.5 Nm
To Next Page
Loading...
