Before overhauling, clean the assemblies and make sure they are integral and complete. Tidy up detached or disassem-
bled parts with their securing elements (screws, nuts, etc.) into special containers.
Check the integrity of the parts that prevent the loosening of screws: split washers, split pins, clips, etc. Self-locking nuts
with nylon inserts must always be replaced.
Avoid contact of rubber with diesel fuel, petrol or other incompatible substances.
Before pressure washing mechanical parts, protect electrical connectors and any control units.
The tightening of screws and nuts should always be carried out according to directions. FPT’s sales and assistance net-
work is available to provide any clarifications necessary to carry out any repair work not covered by this document.
Before welding:
- Disconnect all electronic control units and unplug the power cable from the battery’s positive terminal (connecting
it to the chassis ground) and connectors.
- Remove paint by using proper solvents or paint removers and clean relevant surfaces with soap and water.
- Wait approximately 15 minutes before proceeding with welding.
- Usesuitablefire-resistantprotectionstoprotecthoses or other components in which fluids or other flammable
materials flow when welding.
Should the vehicle be subjected to temperatures exceeding 80C (dryer ovens), remove the electronic control units.
The disposal of all liquids and fluids should be carried out in strict compliance with specific regulations in force.
Wear all required P.P.E and garments when called for by the operation at issue Contact with moving parts may cause
serious injuries. Use suitable, preferably tight-fitting garments and avoid wearing jewellery, scarves, etc.
Do not leave the engine running in workshops not equipped with a pipe to extract exhaust fumes outside.
Do not breathe fumes from heating or welding of paint, as they are harmful; operate outdoors or in well-ventilated areas.
Wear an appropriate respirator in the presence of paint dust.
Avoid contact with hot water or steam from the engine, radiator and hoses as they could cause serious burns. Avoid
direct contact with liquids and fluids inside vehicle systems; consult the 12 remedy points sheet if accidental contact
occurs.
6
CURSOR SERIES
Base - 03/2015 Print P4D32C006 E
To Next Page
Loading...
