2/2
2. Replacement and adjustment of parts
27450-5
27450-5
Order sorter section
(2) When the paper guide opens (raise)
• Adjust the attaching position of the paper guide open sensor so that the angle between the paper guide and the order
classification section is at right angle. (two screws)
(3) If the paper guide opens and closes repeatedly and the stop position is not stable, check the tension of the paper
guide motor timing belt.
☞20020-5
Paper guide open sensor
Screws
Screws
Paper guide close sensor light-tight plate
90°
Paper guide
Print conveyor
Adjust in parallel.
G074249
Distributed by: minilablaser.com
To Next Page
Loading...