Paper advance unit 2
1/2
2. Replacement and adjustment of parts
26570
26570
Adjusting the arm position
!
!!
! Procedure
1. Remove paper advance unit 2.
☞26550
2. Remove the upper guide (right). (four screws, one plate)
3. Remove the upper guide (left). (four screws)
Adjusting the position of the arm (right)
1. Perform adjustment so that the dimension between the lower guide of the arm unit and the rail is
53.9±0.2 mm. (one screw)
Upper guide (right)
Upper guide (left)
Plate
G068549
Lower guide
Rail
53.9±0.2 mm
G069798
Distributed by: minilablaser.com
To Next Page
Loading...