For safe operation
1/3
1. Cautions for work
10030
10030
For saf e opera tion
For safe operation
!
!!
! General precautions
• Prior to any part replacement or mechanical adjustment, be sure the main power supply is turned off.
• Since the work which uses key operations cannot turn off the circuit breaker, mechanical operation check during it
requires particular attention.
IMPORTANT
• Ground wires (green and yellow) are connected to the covers and units of the machine.
For reassembly, be sure to connect the ground wires as they were.
• Be sure to perform an operation check after replacing or adjusting any parts (or units).
!
!!
! Precautions for processing solutions
• This system uses non-pharmaceutical poison and toxic processing solutions which are dangerous to drink in. Direct
contact with processing solutions may irritate eyes.
When handling processing solutions, wear safety goggles.
If a processing solution has been ingested accidentally, immediately rinse the mouth out with water, and drink one or
two cups of water. Contact a physician as soon as possible, and then vomit the solution according to the physician's
instructions.
If processing solution gets into eyes, immediately rinse them under running water for at least 15 minutes, and then
contact a physician.
• Direct contact with processing solutions may irritate the skin and may cause an allergic reaction.
When handling processing solutions, be sure to wear rubber gloves and clothing for workwear, to avoid direct contact.
If there is a possibility of direct or indirect exposure to a processing solution, wash with soap and rinse with lots of
water, after completion of work.
• Processing solution stains on your clothing may result in discoloration or fading. When handling processing solutions,
wear clothing for workwear.
Distributed by: minilablaser.com
To Next Page
Loading...