11/13
4. Troubleshooting
40900
40900
Attention message: F replenishment
No. 00914[F]
PSR is running out.
Countermeasure message
Add 12 liters PSR to the PSR replenishment tank.
Attention message release
YES
NOTE
• Even if the above attention message is shown, printing can be continued until the message ☞No. 00916[F] PSR is empty. is shown.
• The above attention message starts condition check after Start Up Check is performed.
Condition
NOTE
• Attention message No. 00914 is not shown while the automatic Daily Setup is performed.
Check Point
Diagnosis
NOTE
• To access the wiring diagrams, click Wiring diagrams in Bookmarks.
• You can select from two methods to make solution from PSR tablets. Although the ratio of water to tablets is slightly different
between these methods, it does not affect solution quality.
1. Dissolve three tablets in 12 liters of water, then replenish this solution into the replenishment tank.
2. Dissolve three tablets in 15 liters of water, then replenish 8 liters of this solution into the replenishment tank.
Suffix number Condition
00000 • PSR (Upper) Replenishment Solution Level Sensor turns off.
• The power supply is turned on when PSR (Upper) Replenishment Solution Level Sensor is off.
Add PSR. -
Check the PSR (Upper) Replenishment Solution Level Sensor status via Input Check.
☞35220
Failed part Manual No.
PSR (Upper) Replenishment Solution Level Sensor
☞63280
F replenishment I/O PCB ☞66800
Processor control PCB ☞66200
Distributed by: minilablaser.com
To Next Page
Loading...