Processor Settings
1/3
3. Mode
33003
33003
Pump Output Amount Setting[F]
Description for each specification
In this section, the location of information varies depending on the specification. See below for the description for each specification.
• For [N] and [SM] specifications, see ☞Pump Output Amount Setting [N] [SM].
!
!!
! Display
Bringing up the display
Maintenance: 2260 → Extension → Processor Settings → Pump Output Amount Setting
!
!!
! Explanation
!
!!
! Pump Output Amount Setting (Input range: 0.1 to 200.0 ml)
By Pump Output Amount Measurement via F: Functions, output amount of each replenisher pump is measured, and the measured
values are entered.
!
!!
! F: Functions
!
!!
! Pump Output Amount Measurement
Use this function to measure the output amount of each pump.
For the operation procedures, see Operator's Manual - Additional Operations - Measuring the pump output amount.
!
!!
! Mixing Replenisher
There are two functions in Manual Open: creating replenishment solution and resetting the remaining amount of the replenishment
solution.
• Do not return the replenishment solution used for measuring the output amount to the replenishment tank because this amount is
subtracted from the total replenishment solution amounts.
• When restarting the process without draining the replenishment solution from P1R/P2RA/P2RB after taking countermeasures
against replenisher section errors,
☞No. 00912[F] is shown if adding water to the replenishment tank and performing Mixing
Replenisher with turning on all the (upper) and (lower) replenishment solution level sensors (ON: the state of solution filled).
At this time, the remaining amount of replenishment solution is reset.
• ☞ No. 00913[F] occurs if performing Mixing Replenisher with # # # (lower) replenishment solution level sensor on (EXCEPT FOR
the case that all the (upper) and (lower) replenishment solution level sensors of P1R/P2RA/P2RB are on, which is the state of
solution filled).
• The same process can be performed as Processor Standard Setting→Processor Set Up Mode→Mixing Replenisher.
M5467-00
Distributed by: minilablaser.com
To Next Page
Loading...