Zigzag adjustment
1/4
2. Replacement and adjustment of parts
26810
26810
Zigzag adjustm ent
Adjusting the zigzagging of the paper advance section
This section explains the zigzagging adjustment procedure for paper magazines A, B and C. For the adjustment procedure for paper
magazine A2, see the following.
!
!!
! Procedure
1. Check the condition of the paper magazine.
☞22000
2. Adjust the zigzagging of the exposure advance unit.
See ☞ Adjusting the paper zigzagging in the exposure advance unit in 36080.
IMPORTANT
• When adjusting the zigzagging of the exposure advance unit, make a test print using the maximum size of
paper which is in use.
• If the exposure advance adjustment is performed for any one of magazine A, A2, B, or C, the correction is
complete.
• Measure the dimensions between 0 mm-line and 254 mm-line on right and left edges of the test print and
check that the differences are within 0.2 mm. If it is within 0.2 mm, you do not have to adjust it.
NOTE
• There is another method to check the difference. Cut the paper at the center and put them together to check the difference
between 0 mm-line and 254 mm-line.
3. Adjust the zigzagging of the magazine mount.
☞22100
See
☞26820☞How to adjust the zigzagging in paper supply unit A2.
Items to confirm
All Check if leveling of the system is completed correctly.
Magazine deck Check that the shutter open/close arm works properly. (If the printer door is closed, the shutter
open/close arm moves 10 mm and more at the outlet section of the magazine.)
A
Left
Right
Rear end
Paper advance direction
G068467
Distributed by: minilablaser.com
To Next Page
Loading...