Frontier LP7700 - Standard Replenishment Amount Setting[F

Processor Settings
1/1
3. Mode
33002
33002
Standard Replenishment Amount Setting[F]
!
!!
! Display
Bringing up the display
Maintenance: 2260 → Extension → Processor Settings → Standard Replenishment Amount Setting
!
!!
! Explanation
NOTE
• Enter the service personnel password (2260) to set the standard replenishment amount of P1R, P2RA and P2RB.
!
!!
! Standard Replenishment Amount Setting (Input range: 0.1 to 500.0 mL/m2)
The standard replenishment amount of P1R, P2RA, P2RB and PSR can be specified on the Standard Replenishment Amount Setting.
!
!!
! Replenishment rate by magazine (Initial value: 1.0 for P1R/P2RA/P2RB/PSR) (Input range: from 1.0 to
2.0)
The standard replenishment amount of P1R/P2RA/P2RB, PSR can be specified for each Width, Paper Surface and Magazine ID.
• Example: Basic replenishment amounts when Replenishment rate by magazine of P1R/P2RA/P2RB is set to 1.2 for a paper
magazine whose Width is 127 mm and Paper Surface is (1)
• In the replenishment package or process specification change, change the standard replenishment amount only when the instruction
for changing the standard replenishment amount arrives from the manufacturer.
• Do not change the standard replenishment amount without the instruction from the manufacturer.
• If using professional paper, change Replenishment rate by magazine only when the instruction is given by the manufacturer.
• Do not change the Replenishment rate by magazine without the instruction from the manufacturer.
Processing
solution
Basic
replenishment
amount
Replenishment rate by
magazine
Basic replenishment amount after Replenishment rate
by magazine is changed
P1R 108.0mL/m2 1.2 129.6mL/m2
P2RA 108.0mL/m2 1.2 129.6mL/m2
P2RB 108.0mL/m2 1.2 129.6mL/m2
PSR 248.0mL/m2 1 248.0mL/m2
M5466-00
Distributed by: minilablaser.com