9/13
4. Troubleshooting
40900
40900
Attention message: F replenishment
No. 00912[F]
Replenishment solution was created. Initialize replenishment data and restart
replenishment.
Attention message release
YES or NO
• Select YES to initialize the replenishment data.
• When Mixing Replenisher is performed by mistake while the replenishment solution is created normally, select NO.
Maintain the status without initializing the replenishment data.
Condition
Condition
If all the (upper and lower) replenishment solution level sensors of P1R, P2RA and P2RB are turned on when starting the Mixing
Replenisher operation.
• When restarting the process without draining the replenishment solution from P1R/P2RA/P2RB after taking countermeasures against
replenisher section errors, attention No. 912 is shown if adding water to the replenishment tank and performing Mixing Replenisher
with turning on all the (upper) and (lower) replenishment solution level sensors (ON: the state of solution filled).
Distributed by: minilablaser.com
To Next Page
Loading...