2/3
1. Cautions for work
10030
10030
For safe operation
!
!!
! Precautions against electric shock
• If any case you have to take care of wiring for the power such as moving the system, ask a qualified professional
electrician for work. Do not forget to ground the system.
• Pay attention to avoid shocks when performing troubleshooting, wiring checking, or voltage/current measurement.
• When replacing a fuse or PCB, be sure to turn off the circuit breaker and the main power supply. Wait for 10 seconds
or more before replacement.
!
!!
! Precautions for operating rotary section
• Be careful for your hands, hair, clothes, etc., not to be caught under the gear, chain, belt, roller, fan and other rotating
parts.
Do not remove covers other than those specified.
Be sure to turn off the circuit breaker and main power supply of this machine before performing any operation.
Keep away your hands from the system during operation.
If your hands are caught and you cannot move, ask someone to turn off the circuit breaker at once.
!
!!
! Precautions for operating heating section
• The processing solution heater, dryer heater and motor, etc. become very hot.
If you directly touch them during operation or right after operation, you may get burnt.
When replacement of parts or maintenance is performed, make sure that the temperature is fully lowered.
After temperature fully falls, carry out the operation by turning off the circuit breaker and the main power supply.
Cooling time, such as the heater section and the motor, changes with work states. Turn off the circuit breaker and
main power supply. Then, perform the work after the temperature has become low enough.
If you have got burnt, cool the burn with running water and contact a physician as soon as possible.
Distributed by: minilablaser.com
To Next Page
Loading...