3. Mode
36000
2/2
36000
Printer Mechanical Adjustment
!
!!
! Adjusting procedure
!
!!
! Paper Sensor LED Light Intensity Adjustment
1. Check that each printer cover of the printer section and printer doors are closed.
2. Perform Paper Sensor LED Light Intensity Adjustment.
NOTE
• The LED light intensity value of each sensor is not shown if the service personnel password has not been entered.
• After Paper Sensor LED Light Intensity Adjustment is completed normally, OK is shown.
OK: When the LED light intensity of each sensor is from 1 to 169
• After Paper Sensor LED Light Intensity Adjustment is not completed normally, − is shown.
−: When the LED light intensity of each sensor is 0 or 170 or more
Distributed by: minilablaser.com
To Next Page
Loading...