3/3
3. Mode
36040
36040
Printer Mechanical Adjustment
3. Carry out the correction so that the magenta and yellow lines make a straight line with cyan line in the
vertical direction at 0 on the test print.
IMPORTANT
• Check line 160 usually.
• If you do not have paper of 178 mm or wider, make a test print with the widest paper you have, then measure
the length of the most outside line.
• If there is no image where magenta and cyan lines make one line, carry out the fine adjustment by 0.1 dot.
• Check the line with the most outside chart of the test print.
NOTE
• When correcting the magenta line to the right, input minus correction value.
• When correcting the magenta line to the left, input + correction value.
4. Enter the correction value.
5. Perform Test Print Confirmation of Functions.
6. Check the magenta and yellow lines make a straight line with cyan line in the vertical direction at 0 on
the test print again.
7. Carry out the Exposure Position Adjustment again.
☞36030
Distributed by: minilablaser.com
To Next Page
Loading...