Attention message: Scanner/ Film Carrier
1/2
4. Troubleshooting
41300
41300
Attent ion me ssage: Sc anner/ F ilm Car rier
No. 01302−01454
Attention messages not explained in the Service Manual
Condition
IMPORTANT
• Attention messages not explained in this Service Manual are listed in the table.
For corrective actions, see the EZ Controller Service Manual, Scanner Service Manual, Connection Unit Service
Manual and Troubleshooting Manual (scanner).
See the EZ Controller Service Manual.
See the Scanner Service Manual.
NOTE
• In the Attention message table, attention message numbers that are not used currently may be listed.
See the Scanner Service Manual.
Attention message table
No. 01302 Would you like to stop scanning?
No. 01456 Could not start the scanner.
No. 01457 The scanner has canceled processing. Processing will quit.
Attention message table
No. 01305 Photometry Section may be dirty.
No. 01306 Update the light source. If film remains in the Film Carrier, remove it.
No. 01313 The Focus Adjustment was not completed yet.
No. 01314 Light source evenness is out of allowable range.
No. 01315 LED Light Source temperature is being adjusted. process cannot be continued.
No. 01316 Focus Adjustment failed.
No. 01317 Failed to perform the Scan Position Auto Correction.
No. 01318 Close the Scanner Unit Cover.
No. 01319 Scanner type was changed. The system will be restarted.
No. 01320 There may be dust on the AFC opening.
Attention message table
No. 01400 Lock the Film Carrier.
No. 01401 Attach the Film Carrier.
No. 01402 Attach the 135/240 AFC.
No. 01303 Undeveloped cartridge. Cannot process.
No. 01404 The IX frame data is incomplete.
No. 01405 Remove the 135 film from the Film Carrier.
No. 01406 Remove the 240 film from the Film Carrier.
No. 01407 Remove the 110 film from the Film Carrier.
No. 01408 Remove the 120 film from the Film Carrier.
No. 01409 Set the lane for the Film Carrier.
No. 01410 Confirm the film stop position in the Film Carrier.
No. 01412 The film is upside down. Would you like to continue processing?
No. 01413 Input the frame number
No. 01414 The FID number was not detected.
No. 01416 Select the 240 lane.
No. 01417 Close the Mount Insertion Cover.
No. 01421 Confirm the stop position of all the frames to be processed.
Distributed by: minilablaser.com
To Next Page
Loading...