5/5
4. Troubleshooting
41800
41800
Attention message: Software upgrade
Diagnosis
NOTE
• To access the wiring diagrams, click Wiring diagrams in Bookmarks.
3 Procedure (If the recovery software does not start normally)
Start the recovery software in the following conditions.
If changing the settings, be sure to write down the current settings, and restore the settings after the operation.
1. Directly connecting the operation PC and printer
• If connecting them with a LAN cable (cross cable), set Link Speed & Duplex of the operation PC to Auto Detect.
Bringing up the display
Right-click the My Computer icon. → Manage (G) → Device Manager → Double-click Network adapter. → Right-
click the adapter to use. → Click Properties. → Click the Advanced tab.
• If connecting them with a LAN cable (straight cable), use a HUB to connect them.
2. Set the IP address of the operation PC to 192.168.1.12, and subnet mask to 255. 255. 255. 224.
Bringing up the display
Start → Control Panel → Network Connections → Right-click Local Area Connection. → Click Properties.
3. If the OS of the operation PC is Windows XP, set Firewall to OFF.
Bringing up the display
Start → Control Panel → Security Center → Firewall
4. Press the Windows key on the keyboard.
5. Run the recovery software, NPIPLVUP.
Start → Programs → NPIPLVUP
The recovery software display is shown, and recovery process automatically starts.
When the recovery process finishes, the display is closed.
IMPORTANT
• It takes about one minute to complete the recovery process. Do not turn off the PC power supply during the
process.
6. If you changed the IP address, subnet mask and firewall settings, restore them.
7. Restart the printer/processor section.
Failed part Manual No.
Printer I/F main PCB ☞66005
Distributed by: minilablaser.com
To Next Page
Loading...