2/2
4. Troubleshooting
46300
46300
Error message: Scanner/ Film Carrier
See the EZ Controller Service Manual.
NOTE
• In the Error message table, error message numbers that are not used currently may be listed.
See the Connection Unit Service Manual.
NOTE
• In the Error message table, error message numbers that are not used currently may be listed.
No. 06424 Mount Unit operation error.
No. 06425 Mount detection error.
No. 06426 The lane is out of position.
No. 06429 System error. (AFC / Scanner control PCB)
No. 06431 Auto focus error.
No. 06432 Mount insertion operation error.
No. 06433 Mount detection error.
No. 06434 Mount detection (inlet) error.
No. 06435 Mount insertion operation error.
No. 06436 Mount elevator operation error.
No. 06437 Mount eject operation error.
No. 06438 135 Cleaning Leader has stopped.
No. 06439 The film strip is too short for processing.
No. 06441 The 120 Cleaning Leader has stopped.
No. 06442 The perforation of the film may be broken.
No. 06443 Move Table operation error.
No. 06444 Cartridge is out of position.
No. 06445 End Perforation Sensor error.
No. 06446 Film was set to the incorrect lane.
Attention message table
No. 06463 Scanner data receive error
Attention message table
No. 06447 I/O extension PCB could not be detected.
No. 06448 The Connecting Unit was unlocked.
No. 06449 Sensor LED Light Intensity Adjustment was not executed.
No. 06450 Film Sensor 1 error.
No. 06451 Film Sensor 2 error.
No. 06453 Film has stopped in the Connecting Unit.
No. 06455 Film cut operation error.
No. 06456 Arm operation error.
No. 06457 Interlock error.
No. 06458 Film Processor error. Film will be ejected to the Negative Stocker.
No. 06459 Manual insertion was detected. Film auto loading cannot continue to the Scanner. Quit the process.
No. 06460 Advance Motor control error.
No. 06461 Film Advance Guide 1 has opened. The process was stopped.
No. 06462 The Cleaning Leader has stopped in the Connecting Unit.
Error message table
Distributed by: minilablaser.com
To Next Page
Loading...