Volume Mode
6. To exit or to change the axis and position of the image within the Niche display, press
the [Trackball Menu Navigation] key again.
Position the images in the niche mode display with the trackball.
Use the upper trackball key to change the function of the trackball from image
position to axis position.
Remarks:
Selection and Rotation of the Niche mode image may also be performed with the navigation wheel.
Use the [Single] screen format key and the [Quad] screen format key to change from full Niche
display and vice versa.
Use the rotary controls [X-axis] , [Y-axis] , [Z-axis] to rotate the volume about any one of the axes.
Rotation about X-, Y- and Z-axis can be performed liberally.
Perform the parallel slicing of the image axis by rotating the [Par. shift] rotary control for the selected
reference image.
Following functions are excluded with this mode:
• Measurements
• Identification of sections
• Display of orientation help
Voluson
®
730Pro - Basic User Manual
105831 Rev. 0 11-27
To Next Page
Loading...
