BGS2T AT Command Set
7.5 ATD><n>
BGS2T_ATC_V01.301 Page 143 of 554 1/31/12
c
7.5 ATD><n> Mobile originated call from active memory using index
number
Syntax
Command Description
TA attempts to set up an outgoing call to the stored number. The termination character ";" is mandatory since
dialing from a phonebook is only supported for voice calls and for sending *# codes of Supplementary Services
or other functions.
Parameter Description
Integer type memory location in the range of locations available in the selected memory, i.e. the index number
returned by AT+CPBR.
String of GSM modifiers:
I Activates CLIR (disables presentation of own phone number to called party)
i Deactivates CLIR (enables presentation of own phone number to called party)
Notes
• This command may be aborted generally by receiving a character during execution. Abortion is not possible
during some states of connection setup such as handshaking.
• The command is not applicable to data calls. Any attempt to dial a data call number from <n> causes the
result code "NO CARRIER" to appear.
• Parameter <mgsm> only if no *# code is within the dialing string.
Exec Command
ATD><n>[<mgsm>];
Response(s)
ERROR
+CME ERROR: <err>
If no dialtone (parameter ATX2 or ATX4):
NO DIALTONE
If busy (parameter setting ATX3 or ATX4):
BUSY
If connection cannot be set up:
NO CARRIER
NO DIALTONE
When TA returns to command mode after call release:
OK
If successfully connected:
OK
PIN ASC0 MUX1 MUX2 MUX3 Last Reference(s)
+ + + ± ± - - V.250
<n>
(num)
<mgsm>
(str)
To Next Page
Loading...
Need help?
General
