BGS2T AT Command Set
13.19 AT^SMGL
BGS2T_ATC_V01.301 Page 399 of 554 1/31/12
c
13.19 AT^SMGL List Short Messages from preferred store without set-
ting status to REC READ
The write command allows to select a status type and lists, from the message storage <mem1>, all messages
that currently have the specified <stat>. The major difference over the standard command AT+CMGL is that the
status of the listed messages remains u n c h a n g e d (unread remains unread).
The execute command is the same as the write command, but uses the given default of <stat>.
Syntax
Notes
• The selected <mem1> can contain different types of SMs (e.g. SMS-DELIVERs, SMS-SUBMITs, SMS-STA-
TUS-REPORTs and SMS-COMMANDs), the response may be a mix of the responses of different SM types.
TE application can recognize the response format by examining the third response parameter.
• Users should be aware that when using this AT command quickly after SIM PIN authentication the SIM data
may not yet be accessible, resulting in a short delay before the requested AT command response is returned.
See Section 19.1, Restricted access to SIM data after SIM PIN authentication for further detail.
Test Command
AT^SMGL=?
Response(s)
same as AT+CMGL
Exec Command
AT^SMGL
Response(s)
^SMGL: (For default values of <stat>, see "Section 13.1, SMS Parameters.)
OK
Write Command
AT^SMGL=<stat>
Response(s)
same as AT+CMGL
PIN ASC0 MUX1 MUX2 MUX3 Last
+ + + + + - -
To Next Page
Loading...
